Nyrapag 20" Chainsaw Chain for DEWALT DCCS677 — 2-Pack DW01DT620 Replacement, 20-inch Compatible

Nyrapag 20" replacement chainsaw chain is a two-pack of OEM-compatible chains designed to fit DEWALT DCCS677 series saws (DW01DT620 compatibility) to restore cutting performance quickly.

If your DEWALT DCCS677 60V chainsaw is running dull or the chain has been damaged, this Nyrapag replacement chain set gives you two ready-to-install 20-inch chains that match the DW01DT620 specification. Each chain is manufactured to fit 20" guide bars used on DCCS677B, DCCS677Y1, DCCS677Z1 and other DW01DT620-compatible models, so you can get back to pruning, limb removal and firewood cutting without hunting for model-specific parts.

Will this chain fit my DEWALT DCCS677 chainsaw?

Yes — these chains are sized and slotted to replace DEWALT part number DW01DT620 and are built for 20-inch guide bars used on the DCCS677 family. Measure your current chain length and pitch to confirm match if you have a non-standard setup.

• Compatible with DEWALT DCCS677B, DCCS677Y1, DCCS677Z1 models
• Designed for 20" guide bars (check your bar for 20" marking)
• Direct replacement for DEWALT part DW01DT620
• Sold as a 2-pack for immediate spare or swap-out

How easy is installation and maintenance?

Installation follows the same steps as the original DEWALT chain: release bar tension, route the chain over the sprocket and bar, then re-tension and lubricate. Basic maintenance — sharpening, proper tensioning and chain oiling — keeps the chain cutting efficiently and extends service life.

• Fits standard DCCS677 tensioning and mounting points
• Requires regular sharpening for optimal cutting performance
• Use adequate bar and chain oil during operation
• Keep correct tension to prevent wear and reduce risk of derailment

What performance can I expect from these replacement chains?

These chains restore slicing and ripping performance similar to the original DEWALT specification when properly matched and maintained. They are intended for general homeowner and light professional tasks such as limbing, pruning and cutting smaller firewood.

• Engineered to meet the DW01DT620 fit and cutting profile
• Suitable for routine yardwork and light-duty cutting
• Two chains in the package give you a backup for continuous work
• Consistent tooth spacing and pitch for smooth feed

Who is this for? If you own a DEWALT DCCS677-series 60V chainsaw with a 20" bar and need an affordable, ready-to-install replacement, this Nyrapag 2-pack is made for homeowners, property managers and light-duty contractors who prefer to keep a spare chain on hand. These chains are a practical choice when the original DW01DT620 part is unavailable or when you want a cost-effective way to restore cutting capability quickly. Always follow DEWALT safety and maintenance guidance when fitting replacement parts.