GJK Replacement Lopper Blades for Fiskars PowerGear 25in/31in & PowerGear 2 27in/32in, 2-Pack — Alloy Steel PTFE Coating

These are two high-strength replacement lopper blades from GJK designed to fit Fiskars PowerGear 25"/31" and PowerGear 2 27"/32" models, delivering clean cuts on branches up to 2 inches thick.

When your original lopper blades become dull, bent, or damaged, swapping in a matched replacement restores cutting performance without replacing an entire tool. GJK crafted these blades from alloy steel with a PTFE low-friction coating to combine edge retention and smoother slicing. Before ordering, confirm your lopper's length and screw-hole alignment to ensure compatibility.

How do these blades improve cutting compared with worn originals?

New GJK blades renew the geometry and sharpness lost to wear, allowing the cutting edges to shear wood more efficiently. The alloy-steel construction resists bending while the PTFE finish reduces drag, so cuts stay cleaner and the effort required is reduced.

• Alloy steel for consistent edge strength and durability
• PTFE low-friction coating minimizes sap and debris sticking
• Engineered edge profile for precise shearing of branch fibers

Will these replacements fit my Fiskars PowerGear loppers?

These blades are made to match the mounting pattern and blade length for Fiskars PowerGear 25"/31" and PowerGear 2 27"/32" models, but fit depends on screw-hole spacing and exact model variant. Measure your existing blade and check mounting holes before purchase to ensure a proper fit.

• Designed for Fiskars PowerGear 25" and 31" loppers
• Also compatible with PowerGear 2 27" and 32" lengths
• Confirm screw-hole alignment and blade length prior to installation

What is the cutting capacity and performance I can expect?

GJK replacement blades are rated to cut branches up to approximately 2 inches in diameter when used correctly. They work best on dry or slightly green wood and deliver cleaner cuts when used with compatible lopper handles and properly adjusted hardware.

• Rated for up to 2-inch branch diameter cuts
• Sharp edge and low-friction coating for neater cuts
• Pair with correct handle length and leverage for maximum efficiency

How do I install and maintain the new blades?

Installation requires removing the old blade, aligning the replacement blade to the mounting holes, and securing it with the original fasteners or compatible hardware. Keep blades clean and lightly oiled, check fasteners periodically, and sharpen or replace blades again when cutting quality declines.

• Use original mounting bolts or equivalent hardware for a secure fit
• Wipe blades after use and apply a light oil to prevent corrosion
• Inspect fasteners and blade alignment before each season

Who is this for: These GJK replacement blades suit homeowners, gardeners, and landscape pros who already own Fiskars PowerGear or PowerGear 2 loppers and want a cost-effective way to restore cutting performance. They are appropriate for routine pruning, light tree maintenance, and general garden cleanup where up to 2-inch branches are encountered. If you value clean, efficient cuts and want to extend the life of your existing lopper, these blades are a practical replacement option.