BERPSE Car Drying Nozzle for Milw..ke 18V 2724-20 & 2728-20 — 8" Compact Silicone-Edged Concentrator

BERPSE car drying nozzle is an 8-inch compact air concentrator designed to fit Milw..ke 18V leaf blowers 2724-20 and 2728-20 to speed vehicle drying while protecting paint.

This low-profile nozzle reduces the exposed length of your blower, channels airflow into a focused jet for faster water removal, and includes a silicone edge to prevent scratches during use. It slips onto compatible Milw..ke 18V blower outlets without tools and locks in place for secure operation, letting you dry cars, motorcycles, and trim areas with greater control than a bare blower tip.

How does this nozzle speed up drying on cars?

By narrowing the blower outlet, the nozzle concentrates air into a stiffer, more directed stream that pushes water away from surfaces quicker than a wide, diffuse airflow. Faster water displacement means fewer streaks and less towel finishing.

• Concentrated airflow for stronger surface blow-off
• Short length minimizes turbulence for efficient air transfer
• Better control reduces overspray and fine mist

Will it fit my Milw..ke 18V 2724-20 or 2728-20 blower?

This nozzle is engineered specifically for the Milw..ke 18V single-battery blowers 2724-20 and 2728-20. Installation is a simple push-in connection that snaps into place; no tools required.

• Designed to match nozzle opening and locking feature of listed models
• Push-in snap fit secures without screws or clamps
• Compact 8" overall length; only ~5" extends beyond blower housing

How does the nozzle protect vehicle paint while drying?

The nozzle has a soft silicone protective film around the contact edge so accidental nudges against panels won't scuff or chip paint. That protective layer cushions impacts and creates a non-abrasive barrier between hard plastic and delicate finishes.

• Silicone film reduces friction on trim and bodywork
• Rounded profile avoids sharp contact points
• Can be inspected and replaced if needed for long-term care

How easy is it to install and remove the nozzle?

Installation takes seconds: align, push the nozzle into the blower mouth until it snaps, then give a gentle pull to confirm a firm connection. Removal is just as quick — press, pull, and detach without tools, ideal for quick job changes.

• Tool-free push-in mount for fast swaps
• Clear snap feedback so you know it’s secured
• Compact form helps maneuverability in tight areas

Who is this for? The BERPSE car drying nozzle suits detailers, car enthusiasts, mobile washers, and homeowners who use Milw..ke 18V 2724-20 or 2728-20 blowers and want a quicker, safer way to dry paint, glass, and trim. It’s especially helpful when you need to reduce towel contact, reach crevices, or protect delicate surfaces during fast turnarounds.